A typical M2500 progressive distributor consists of a inlet section, a end section and no less than 3 sections and no more than 10 sections.
A progressive distributor can have 3 to 20 outlets. Twice outlet section (Add “T” after section specification means twice outlet section) have two outlets at both side of the section.
Single outlet section (Add “S” after section specification means single outlet section) have a outlet at one side of the section.
Please pay attention that you can block any out otherwise the progressive distributor can not work.
Max work pressure：25Mpa
Delivery: 0.08ml/cyc ～ 1.28ml/cyc
Lubricant viscosity (under standard temperature): oil≥N68,grease:NLGI 000#～2#
Work temperature: -20℃～+60℃
Max work frequency (with stem):60cyc/min
Max work frequency (without stem):200cyc/min
Manifold number: 3～10
Outlet: Φ6mm length: 1.2～3.5m Φ8mm length1.5～4.5m
M2500 Valve Size
Discharge per Hole（mL/cyc）
Min Working Pressure（MPa）
1.Only the valve size up to 20 can install the indicator;
2. User shall specify changed inlet/outlet diameter, when ordering;
3. Never block outlet of a distributor so as to avoid over pressure damage to the distributor;
4. In order to assemble properly, please machine reserve two fixed holes of the inlet section(or end section) on the machine. Because progressive divider valve, the distance between the fixed holes will change within a little range. Machining two holes per the progressive divider valve actual dimension when fixing the progressive divider valve.